Ireland · Tiling
Wall & floor tiles calculator for Ireland
Tile count using individual tile dimensions. Enter your project measurements to estimate tiles required, include a practical waste allowance and produce an order-ready quantity.
Use the free wall & floor tiles calculator →Measurements needed
Measure the finished project rather than relying only on nominal plan dimensions. Enter all values using the units displayed by the calculator.
How to calculate tiles required
Divide finished area by one tile or slab area, then apply waste and round up.
Set out full tiles from the visual centreline and increase waste for diagonals, patterns, niches and many small cuts.
Worked estimating example
Begin with the example values shown beside each input, then replace them with your own measurements. Check that every dimension uses the same measuring system. Apply a waste allowance that reflects cuts, breakage, spillage, matching batches and site access. The calculator then reports the estimated tiles required in tiles.
Before buying, compare the result with the manufacturer’s current pack coverage or yield. If products are sold only in full packs, order the next whole pack rather than rounding down.
Wall & floor tiles estimating in Ireland
Projects in Ireland commonly use metric dimensions, with imperial measurements sometimes found in older properties. BuildCalc supports both metric and imperial entry so measurements from plans, existing buildings and supplier literature can be reconciled.
Local buying terminology includes timber, plasterboard, slates and paving slabs, with costs normally quoted in EUR (€). Check Irish Building Regulations where applicable and compare merchant pack sizes before ordering.
Common estimating mistakes
- Mixing metric and imperial values in the same calculation.
- Using nominal product dimensions instead of actual coverage or installed size.
- Rounding intermediate values too early or rounding the final order down.
- Applying a generic waste percentage without considering the layout and cutting pattern.
- Treating a material estimate as structural design or regulatory approval.
Frequently asked questions
How much waste should I add?
Use the smallest allowance justified by the real layout. Straight, repetitive work may need less; diagonal patterns, complex cuts, fragile materials and matching batches usually need more. The DIY and Trade settings are starting points, not fixed rules.
Does the calculator replace a supplier quotation?
No. It provides an independent preliminary estimate. Verify current product dimensions, yield, pack coverage, minimum order quantities and delivery constraints with the supplier.
Can I use the result for regulated or structural work?
Use it only for initial material planning. A competent designer, installer or relevant authority should verify safety-critical dimensions, structural capacity and compliance.
Related tiling calculators
Method and review
BuildCalc shows the formula and assumptions so the result can be checked independently. Content is maintained by Chris Feltham and is intended for early-stage DIY and trade estimating. Report a suspected error with the calculator name, inputs, expected result and a reliable supporting source.